पीसने वाले पहिये की स्थापना और उपयोग

1. पीसने वाले पहिये को स्थापित करने और उपयोग करने से पहले, यह देखने के लिए उपस्थिति का निरीक्षण किया जाना चाहिए कि क्या कोई दरार या क्षति है। पीसने वाले पहिये को लकड़ी के हथौड़े से मारा जाना चाहिए, और ध्वनि कुरकुरा होनी चाहिए। उपयोग करने से पहले, GB / T2493 मानक के प्रावधानों के अनुसार एक रोटेशन परीक्षण किया जाना चाहिए, अन्यथा, इसका उपयोग करने के लिए सख्ती से निषिद्ध है। 2. स्थापना से पहले, मशीन टूल की स्पिंडल गति की जाँच की जानी चाहिए, और यह पीसने वाले पहिये पर इंगित कार्य गति से अधिक नहीं होनी चाहिए। 3. केवल विशेष नट रिंच को पीसने वाले पहिये को कसने की अनुमति है, और उन्हें स्पिंडल के दोनों किनारों पर क्रम में धीरे-धीरे कसना चाहिए। नट उचित रूप से कड़े होने चाहिए। अतिरिक्त क्लैंप या खटखटाने वाले उपकरणों का उपयोग करना निषिद्ध है। पीसने वाले पहिये के असंतुलन से बचने के लिए शीतलक को बंद कर दें। 5. पीसने वाले पहिये के छिद्र और पीसने वाले पहिये के स्पिंडल और चक का मिलान GB4674 मानक के प्रावधानों का पालन करना चाहिए। 6. नव स्थापित पीसने वाले पहिये को एक सुरक्षात्मक आवरण के साथ स्थापित किया जाना चाहिए और काम करने की गति निम्नलिखित समय के लिए निष्क्रिय है: बाहरी व्यास वाले पीसने वाले पहियों के लिए 2 मिनट से कम नहीं<400 mm, and no less than 5 minutes for grinding wheels with an outer diameter ≥400 mm. When idling, the operator should not stand in front of the grinding wheel or in the tangential direction.7. Grinding wheels that are not specially used for end face grinding (such as parallel grinding wheels) should not be ground with the end face of the grinding wheel. Grinding wheels that are not specially used for external cylindrical grinding (such as bowl-shaped and cup-shaped grinding wheels) should also not be ground with the outer cylindrical surface of the grinding wheel to avoid breaking the grinding wheel.8. When grinding the workpiece, it is forbidden to push the workpiece with a lever to increase the pressure on the grinding wheel.9. For thin-sheet grinding wheels and cymbal-shaped grinding wheels, if too much force is used during cutting, the grinding wheel may easily stop and get stuck or break, causing damage to the grinding wheel. When cutting workpieces, multiple workpieces cannot be stacked up for cutting to prevent accidents.